Owner’s ManualTMTMTMThis owner’s manual is applicable to the original ScreamMachine with pneumatic front tire and the ScreamMachince Jr with the airle
10continue to slide the handlebar assembly into the fork until the springbuttons engage the holes (A) as shown in figure 7e., and the steeringtube ext
11Figure 7g. Snug the adjusting screw.NOTE: The steering bushings are designed for long life andshould require no maintenance. They do not require oil
12Figure 8c. 6E. Assemble the brake cable. The brake lever is preinstalled on thehandlebars and the brake cable adjusting barrel may be either on thec
13Figure 10a. Figure 10b. WARNING: If you do not understand the procedure to connect thebrake cable, we strongly recommend you seek the help of a qua
14Figure 11. If there is too much slack, the lever will go all the way to the handlebarwithout the brake being applied. If there is not enough slack,
Figure 13. NOTE: The brake system requires a break-in period. You mayhave to repeat procedure 6F often during the first several hours of use.Repeat as
the responsibility of the user to periodically inspect the brake pads forexcess wear and misalignment. If you do not understand how to adjustor reali
177. Razor Safety TipsWARNING TO PARENTS: Kids need to be taught and befrequently reinforced of the importance of safe riding, the rules of theroad an
turning (do this only in an open space free from traffic andobstructions).7E. Riding at night and in low visibility. Do not ride at night or in lowvis
Razor Limited Warranty and RegistrationThe manufacturer warranties this product to be free of manufacturingdefects for a period of six months from dat
2NOTE: This manual contains many “Warnings” and “Cautions”concerning the consequences of failing to maintain or inspect yourbicycle. Because any incid
razor usa llc cerritos, ca 90703 www.razor.comQUESTIONS?Please read the owner’s manual thoroughly. If you still havequestions, check the website fo
31. Parts of the Scream Machine5mm hex (Allen) key6mm hex (Allen) key17mm open end wrench10mm open end wrench for brake cableRazor recommends assembly
42. Proper fit and size adjustments2. Fit. When properly adjusted, the rider should be able to pedalcomfortably and steer with both feet remaining on
5WARNING: Cable operated brakes are very effective but must beadjusted and maintained on a regular basis. Check or have themchecked and adjusted by a
65. Safety check (before each ride)5A. Loose parts. While straddling the Scream Machine, lift the frontwheel off the ground two or three inches and le
7for assembly, it will assure the Scream Machine is properly put togetherand adjusted. ASSEMBLY NOTE: Refer to the list of tools required for assembly
8Install both wheels on the Scream Machine by threading the axle boltsinto the rear cross-beam of the Scream Machine frame. Using a 6mmAllen key, care
9Figure 6. Both wheels installed.6C. Install the fork. Insert the steering tube into the frame as shown in 7a and 7b. Thesteering bushings are preinst
Comments to this Manuals